Subscribe to Our Youtube Channel
Related Manuals for infobit iTrans U3-TR100CB
Summary of Contents for infobit iTrans U3-TR100CB
- Page 1 U3-TR100CB USB 3.2 Gen 1 Extender with USB C and USB B (100m) User Manual V1.0 VER 1.0 www.infobitav.com info@infobitav.com...
-
Page 2: Table Of Contents
Thank you for purchasing this product For optimum performance and safety, please read these instructions carefully before connecting, operating or adjusting this product. Please keep this manual for future reference. Surge protection device recommended This product contains sensitive electrical components that may be damaged by electrical spikes, surges, electric shock, lighting strikes, etc. -
Page 3: Introduction
1. Introduction This USB Extender can extend USB 3.2 Gen 1 5Gbps signal to a distance up to 100m/328ft via a single CAT6a cable. The transmitter features one USB-C and one USB-B selectable input ports. The receiver features one USB-C and three USB-A device ports. Bi-directional 24V PoC (Power over Cable) function allows user to only supply power to either the transmitter or the receiver. -
Page 4: Specifications
4. Specifications Technical USB Protocol USB 3.2 Gen 1 Transmission Rate Up to 5Gbps Transmission Distance 100m/328ft via CAT6a (F/FTP) cable 1.5m/4.9ft via USB cable ESD Protection IEC 61000-4-2: ±8kV (Air-gap discharge), ±4kV (Contact discharge) Connections Input: 1× HOST 1 [USB Type C, 24-pin female] 1×... -
Page 5: Operation Controls And Functions
5. Operation Controls and Functions 5.1 Transmitter Panel Name Function Description Power LED The LED will be on when the transmitter is powered on. Connection signal indicator. ▪ On: Transmitter and Receiver are connected and linked. LINK LED ▪ Off: Transmitter and Receiver are not connected. USB signal indicator. -
Page 6: Receiver Panel
Name Function Description Connects to the HDBT-USB3 port on Receiver with CAT6a cable. HDBT-USB3 Connection signal indicator. LINK LED ▪ On: Transmitter and Receiver are connected and linked. ▪ Off: Transmitter and Receiver are not connected. Uplink USB-C port, connected to a PC or host. HOST 1 It can be used to update HUB firmware. - Page 7 Name Function Description Power LED The LED will be on when the receiver is powered on. Connection signal indicator. ▪ On: Transmitter and Receiver are connected and linked. LINK LED ▪ Off: Transmitter and Receiver are not connected. USB signal indicator. ▪...
-
Page 8: Api Commands
6. API Commands The product supports API commands control. Connect the SERVICE or RS-232 port of the product to a PC, then open a Serial Command tool on PC to send ASCII commands to control the product.The API commands list is shown below. ASCII Commands 1. - Page 9 Example Function Feedback Default Command Set USB host input port (x=1~2) x=1: USB host 1 (USBC) set input 1 Set input USB host 1 set input x x=2: USB host 2 (USBB) get input get input Get USB host input port Input USB host 1 Get USB host input port 5V (x=0~2)
- Page 10 Example Command Function Feedback Default Get RX USB device ports (x=0~4) power status RX all USB device x=0: RX all USB device ports get rx usbd 0 get rx usbd x ports power follow x=1: RX USB device 1 (USBC) power power USB host power...
-
Page 11: Application Example
7. Application Example 9 / 9...
Need help?
Do you have a question about the iTrans U3-TR100CB and is the answer not in the manual?
Questions and answers