Triple Play Application - ZyXEL Communications IES-5000 Support Notes

IES-5000 Support Notes
For this example, assign VLAN 200(PVID) to ENET1 and ENET2. Also, assign
VLAN 10 and VLAN 20 to Port1 and port2 respectively.
CI command:
TGE1> switch port pvid up1 200
TGE1> switch port pvid up2 200
TGE1> port pvc set 7-1-0/33 DEFVAL llc 10 0
TGE1> port pvc set 7-2-0/33 DEFVAL llc 20 0
1.3 Port Isolation
On the IES-5000, you can isolate ports without configuring VLAN groups in the CLI.
CI command:
TGE1> switch isolation enable
2. Prestige 660R-61(P791) Settings
Please refer to the steps in the previous application.

Triple play Application

On the IES-5000, you can use different channels (also known as Permanent Virtual
Circuits or PVCs) for different services. Define channels on each DSL port for
different services and assign each channel a priority, VLAN and ATM Quality of
Service (QoS). The ATM QoS allows you to regulate the average rate and fluctuations
in data rates. This helps eliminate congestion and to allow smooth transmission of real
time data (such as audio and video).
In this application, we will show you how to set up multiple PVCs using the IES-5000.
The following figure shows a network example where the computers want to get
different services (data service for Internet access and video service) from two
networks. Since a smooth video streaming quality is desired, we want to give the
video service a higher priority. To do this on the IES-5000, create a different VLAN
for each service and configure the PVCs with a different VID, priority and ATM QoS.
This allows the video service to have a higher priority over the data service. You can
easily adapt this application for a triple-play service network.
9
All contents copyright (c) 2005 ZyXEL Communications Corporation.