Advertisement
Quick Links
Model
SK-910RAQ*
11~24 VAC/VDC
SK-910RA-4Q
11~24 VAC/VDC
SK-910RAVQ*
SK-910RAV-4Q
SK-910RAV2Q*
SK-910RAV2-4Q
*Only 315MHz models are FCC compliant
Compatible Transmitters:
Fixed Code: 68 billion codes
CODEBUMP™: 18 quintillion (1.8x10
For a full and up-to-date listing of compatible transmitters, visit www.seco-larm.com
SK-910RAQ Series
Miniature RF Receivers
Voltage
Channels
3~13.8 VDC
3~13.8 VDC
3~13.8 VDC
3~13.8 VDC
) codes
19
®
Manual
1
3A Form "C" relay output
1
3A Form "C" relay output
1
5A Transistor ground output
1
5A Transistor ground output
2
3A Transistor ground outputs x2
2
3A Transistor ground outputs x2
315MHz
SK-919 Series Fixed Code
SK-917 Series CODEBUMP
SK-910RAQ shown
Output
433.92MHz
SK-939 Series Fixed Code
SK-937 Series CODEBUMP
Frequency
315MHz
433.92MHz
315MHz
433.92MHz
315MHz
433.92MHz
*
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for ENFORCER SECO-LARM SLI SK-910RAQ Series
Summary of Contents for ENFORCER SECO-LARM SLI SK-910RAQ Series
- Page 1 SK-910RAQ Series Miniature RF Receivers Manual SK-910RAQ shown Model Voltage Channels Output Frequency SK-910RAQ* 11~24 VAC/VDC 3A Form "C" relay output 315MHz SK-910RA-4Q 11~24 VAC/VDC 3A Form "C" relay output 433.92MHz SK-910RAVQ* 3~13.8 VDC 5A Transistor ground output 315MHz SK-910RAV-4Q 3~13.8 VDC 5A Transistor ground output 433.92MHz...
- Page 2 ENFORCER Miniature RF Receivers Introduction: These mini RF receivers are compatible with both code-hopping and fixed-code transmitters (see pg. 1 or visit www.seco-larm.com for a complete, up-to-date listing). They can be used for a variety of applications, such as allowing the same transmitter to arm/disarm a vehicle alarm and open/close a garage door opener.
- Page 3 ENFORCER Miniature RF Receivers Installation Notes: Mount out of sight in a location where it is not surrounded by metal, and where it is not exposed to the weather or moisture. Metal will block the RF signal, resulting in a reduced range.
- Page 4 ENFORCER Miniature RF Receivers LED Indicators (One per Channel): Steady ON Senses signal from a transmitter button whose code was already learned. Fast flash In the code-learning mode. One flash A transmitter button code was learned. Two flashes All previously learned transmitter buttons codes were deleted.
Need help?
Do you have a question about the SECO-LARM SLI SK-910RAQ Series and is the answer not in the manual?
Questions and answers