Table of Contents
Advertisement
Installation Manual
SK-910RBQ (315MHz)
SK-910RB-4Q (433.92MHz)
SK-910RB2Q (315MHz)
SK-910RB2-4Q (433.92MHz)
One- and Two-Channel RF Receivers
Flexible operating voltage: 11~24 VAC/VDC
Up to 500ft (152m) range
Independently programmable channels
Note: Products with model numbers that end with "Q" or that have a round green "Q" sticker are RoHS compliant.
Also Available from SECO-LARM:
SK-910RLQ ........................................... Low-voltage, one-channel receiver, 315MHz
SK-910RVQ ......................................................... Low-voltage, one-channel receiver,
SK-910RL-4Q ................................... Low-voltage, one-channel receiver, 433.92MHz
SK-910RV-4Q ...................................................... Low-voltage, one-channel receiver,
This manual covers only one- and two-channel receivers. For information four-channel receivers, please contact SECO-LARM.
Introduction:
The SK-910RBQ and SK-910RB2Q are wireless receivers that meets the growing demand for
receivers with multiple and independently controlled output functions. These RF receivers are
compatible with both code hopping and fixed code transmitters (see page 4 of this manual for a list of
compatible transmitters). The receivers can be used to control a variety of home automation devices
such as garage door openers, lights, motorized gates, lifts, or other devices remotely.
Installation Notes:
1. Mount the receiver out of sight in a location where it is not exposed to weather or moisture, and
where it is not surrounded by metal. Metal will block the RF signal, resulting in a reduced range.
2. For best range, pull the antenna wire as long and straight as possible. If the receiver receives
interference from local RF activity (e.g., an airport or military base), the antenna wire can be folded.
IMPORTANT: DO NOT CUT THE ANTENNA WIRE.
transistor ground output 315MHZ
transistor ground output, 433.92MHz
SK-910RB2Q shown
*
*
Advertisement
Table of Contents
Related Manuals for ENFORCER SK-910RBQ
Summary of Contents for ENFORCER SK-910RBQ
-
Page 1: Installation Manual
This manual covers only one- and two-channel receivers. For information four-channel receivers, please contact SECO-LARM. Introduction: The SK-910RBQ and SK-910RB2Q are wireless receivers that meets the growing demand for receivers with multiple and independently controlled output functions. These RF receivers are compatible with both code hopping and fixed code transmitters (see page 4 of this manual for a list of compatible transmitters). -
Page 2: Code Learning New Transmitter Button
ENFORCER Two-Channel RF Receiver Code Learning a New Transmitter Button: Each receiver channel can learn the codes of up to 15 different transmitters on a first-in, first-out basis. Below is the procedure for code learning a new transmitter button. 1. Press the channel mode switch of the desired channel for 3 seconds or more. The channel’s LED will start to flash quickly to indicate that it is in learning mode. - Page 3 (SK-910RB2Q only) LP3 antenna program loop 3-Pin antenna port CH 1 CH 2 SK-910RB2Q shown. SK-910RBQ is the Channel Function Switches same, but only has one each: mode Brown function switch is switch; function switch; indicator LED; for channel 1 programming.
-
Page 4: Specifications
ENFORCER Two-Channel RF Receiver Sample Applications: Negative Output Positive Output Positive Power Source Negative Power Source Positive Power Output Negative Power Output — — Power for SK-910RBQ/SK-910RB2Q Power for SK-910RBQ/SK-910RB2Q Typical N.C. Application Typical N.O. Application SD-996C-NUQ Electric Door Strike...
Need help?
Do you have a question about the SK-910RBQ and is the answer not in the manual?
Questions and answers