Getting Started; Set Up The Base - Uniden D3588 User Manual

GETTING STARTED

Set Up the Base

Attach the Stand
Before you attach the stand, you have to decide if you want the phone to rest on a
desk or hang on a wall.
For desktop use
1. Turn the stand so the word
up (it will be on the left).
2. Insert the tabs into the notches marked
at the top of the base.
3. Slide the stand up until it snaps into place.
For wall mount use
1. Turn the stand so the word
up (it will be on the left).
2. Insert the tabs into the notches marked
the bottom of the base.
3. Slide the stand down until it snaps into place.
To Remove the Stand
Pull the locking tabs up and back. Then, slide the stand straight off the opposite
direction you put it on.
Connect the Corded Handset
Use the coiled cord to connect the corded handset to the connector on the left side
of the base.
For wall mount use only
1. On the front of the base, pull the clip
(that holds the corded handset in place) out of its
slot.
2. Rotate the clip 180 degrees.
3. Flip it from front to back and slide it back into the slot.
Connect the Power and Telephone Cords
1. Connect the base AC adapter to the
jack. Route the cords as shown.
TEL LINE
is right-side
Desk
Desk
is right-side
Wall
at
Wall
AC IN 7.8V
DESK
DESK WALL
WALL
DESK
WALL
WALL
jack and the telephone cord to the
DESK
English - 3