Getting Started; Set Up The Base - Uniden D1789 series User Manual

GettinG staRted

set uP the base

attach the stand
Before you attach the stand, you have to decide if you want the phone to rest on a desk or hang
on a wall.
For desktop use
1. Turn the stand so the word
will be on the left).
2. Insert the tabs into the notches marked
top of the base.
3. Slide the stand up until it snaps into place.
For wall mount use
1. Turn the stand so the word
will be on the left).
2. Insert the tabs into the notches marked
bottom of the base.
3. Slide the stand down until it snaps into place.
to Remove the stand
Pull the locking tabs up and back. Then, slide the stand straight off the opposite direction you
put it on.
Connect the Corded handset
Use the coiled cord to connect the corded handset to the connector on the left side of the base.
For wall mount use only
1. On the front of the base, pull the clip (that holds
the corded handset in place) out of its slot.
2. Rotate the clip 180 degrees.
3. Flip it from front to back and slide it back into the slot.
Connect the Power and telephone Cords
1. Connect the base AC adapter to the
jack. Route the cords as shown.
is right-side up (it
Desk
at the
Desk
is right-side up (it
Wall
at the
Wall
jack and the telephone cord to the
AC IN 7.8V
DESK
DESK WALL
WALL
DESK
WALL
WALL DESK
TEL LINE
English - 3