1-Year Limited Warranty - Uniden D3588 User Manual

should be avoided as these might not comply with
FCC RF exposure guidelines.
Industry Canada (I.C.) Notice
Terminal equipment
NOTICE: This equipment meets the applicable
Industry Canada Terminal Equipment Technical
Specifications. This is confirmed by the registra-
tion number. The abbreviation IC before the
registration number signifies that registration was
performed based on a Declaration of Conformity
indicating that Industry Canada technical speci-
fications were met. It does not imply that Industry
Canada approved the equipment.
NOTICE: The Ringer Equivalence Number
(REN) for this terminal equipment is marked on
the equipment itself. The REN assigned to each
terminal equipment provides an indication of
the maximum number of terminals allowed to be
connected to a telephone interface. The termina-
tion on an interface may consist of any combina-
tion of devices subject only to the requirement
that the sum of the Ringer Equivalence Numbers
of all the devices does not exceed 5.
Radio equipment
The term IC before the radio certification number
only signifies that Industry Canada technical
specifications were met. Operation is subject to
the following two conditions: (1) this device may
not cause interference, and (2) this device must
accept any interference, including interference
that may cause undesired operation of the device.
"Privacy of communications may not be ensured
when using this telephone".

1-Year Limited Warranty

Evidence of original purchase is required for
warranty service.
WARRANTOR: UNIDEN AMERICA CORPO-
RATION ("Uniden")
ELEMENTS OF WARRANTY: Uniden warrants,
for one year, to the original retail owner, this
Uniden Product to be free from defects in materi-
als and craftsmanship with only the limitations or
exclusions set out below.
WARRANTY DURATION: This warranty to
the original user shall terminate and be of no
further effect 12 months after the date of original
retail sale. The warranty is invalid if the Product
is (A) damaged or not maintained as reasonable
or necessary, (B) modified, altered, or used
as part of any conversion kits, subassemblies,
or any configurations not sold by Uniden, (C)
improperly installed, (D) serviced or repaired
by someone other than an authorized Uniden
service center for a defect or malfunction covered
by this warranty, (E) used in any conjunction
with equipment or parts or as part of any system
not manufactured by Uniden, or (F) installed or
programmed by anyone other than as detailed by
the owner's manual for this product.
30 - English
STATEMENT OF REMEDY: In the event that
the product does not conform to this warranty
at any time while this warranty is in effect, war-
rantor will either, at its option, repair or replace
the defective unit and return it to you without
charge for parts, service, or any other cost (except
shipping and handling) incurred by warrantor or
its representatives in connection with the perfor-
mance of this warranty. Warrantor, at its option,
may replace the unit with a new or refurbished
unit. THE LIMITED WARRANTY SET FORTH
ABOVE IS THE SOLE AND ENTIRE WARRAN-
TY PERTAINING TO THE PRODUCT AND
IS IN LIEU OF AND EXCLUDES ALL OTHER
WARRANTIES OF ANY NATURE WHATSO-
EVER, WHETHER EXPRESS, IMPLIED OR
ARISING BY OPERATION OF LAW, INCLUD-
ING, BUT NOT LIMITED TO ANY IMPLIED
WARRANTIES OF MERCHANTABILITY OR
FITNESS FOR A PARTICULAR PURPOSE. THIS
WARRANTY DOES NOT COVER OR PROVIDE
FOR THE REIMBURSEMENT OR PAYMENT
OF INCIDENTAL OR CONSEQUENTIAL DAM-
AGES. Some states do not allow this exclusion or
limitation of incidental or consequential damages
so the above limitation or exclusion may not
apply to you.
LEGAL REMEDIES: This warranty gives you
specific legal rights, and you may also have other
rights which vary from state to state. This war-
ranty is void outside the United States of America
and Canada.
PROCEDURE FOR OBTAINING PERFOR-
MANCE OF WARRANTY: If, after following
the instructions in the owner's manual you are
certain that the Product is defective, pack the
Product carefully (preferably in its original
packaging). Disconnect the battery from the
Product and separately secure the battery in its
own separate packaging within the shipping
carton. The Product should include all parts and
accessories originally packaged with the Product.
Include evidence of original purchase and a note
describing the defect that has caused you to return
it. The Product should be shipped freight prepaid,
by traceable means, to warrantor at:
Uniden America Service
4700 Amon Carter Blvd.
Fort Worth, TX 76155
As an Energy Star® Partner,
Uniden has determined that this
product meets the Energy Star®
guidelines for energy efficiency. Energy Star® is a
U.S. registered mark.
x Uniden® is a registered trademark of Uniden
America Corporation.
x The pictures in this manual are for example only.
Your phone may not look exactly like the pictures.
Minimum size: 0.375 in wide (9.525 mm)
Minimum drawing size (with clear space) = 0.555 in (14.1 mm) wide