Getting Started; Installing Your Phone - Uniden DECT 1535 Series Owner's Manual

GETTING STARTED

Installing Your Phone

1. Unpack all handsets, battery packs,
Charge the Battery
and battery covers. If you need to
remove a battery cover, press in on
the notch and slide the cover down
and off.
2. Line up the battery connector with the jack inside the handset.
(The battery connector will only fit one way.)
3. Push the connector in until it clicks into place; tug gently on the
wires to make sure the battery pack is securely connected.
4. Replace the battery cover and slide it into place.
5. Connect the AC adapters to the
each charger. Set the plugs into the notches.
6. Plug the other end of the adapters into standard 240V AC outlets.
7. Place one handset in the base and the other(s) in the charger(s)
with the displays facing forward. The charge LED on each handset
should light up; if it doesn't, reseat the handset or try plugging the
AC adapter into a different outlet.
#
Charge all handsets completely (about 15 hours) before using
them.
Use the telephone cord to connect the
Connect the Telephone Cord
standard telephone wall jack.
1. Pick up the handset from the cradle and press
Test the Connection
hear a dial tone, and the display should say Talk.
jacks on the base and on
DC IN 9V
jack on the base to a
TEL LINE
. You should
TAlk
5