Save Yourself A Call; Problems With Your Computer - HP C1593B - SureStore DAT Tape 5000e Drive Installation Manual

HP SureStore DAT
Installation Troubleshooting

Save Yourself a Call

Problems with Your Computer

Problem
The computer does not
boot up.
The computer boots
but then hangs.
The computer does not
recognize the tape drive.
3-2
The first step in problem-solving is establishing whether the problem lies
with the cartridge, the drive, the host computer and its connections, or with
the way the system is being operated. If none of the following advice helps
you to solve the problem, call for service. The HP technical support
numbers are listed in the "Customer Support" topic in the electronic User's
Guide on the HP SureStore Tape CD-ROM.
Possible Cause
If you have just installed a SCSI
host adapter card in your
computer and the computer did
not boot up when you switched it
on, the new adapter is the likely
cause of the problem.
This might be caused by conflicts
in your hardware or software
configuration, such as two devices
with the same SCSI ID or improper
termination of the SCSI bus.
The tape drive may have been
switched on after the computer
was booted up. The computer
checks for SCSI devices only at
power-on.
The power cable or SCSI cable
may not be connected properly.
Potential Solution
Refer to your host adapter
documentation to check that the
adapter is configured correctly.
Make sure that each device
connected to the SCSI controller
has a unique SCSI ID. Check that
the SCSI bus is actively
terminated. (The electronic User's
Guide on the HP SureStore Tape
CD-ROM provides information on
configuring your SCSI bus. Also
refer to the documentation for
your SCSI controller and any other
SCSI devices you may have.)
Switch on the tape drive, then
switch the computer off and then
on again.
Make sure that the power cable
and SCSI cable are firmly
connected.