Trouble-Shooting; Putting Your Water Timer Out Of Operation; Technical Data - Gardena WT 1030 Operating Instructions Manual

G

6. Trouble-Shooting

Fault Possible cause
Not able to open the Battery capacity too low
Water Timer manually (3 LED s flash).
using "ON / OFF".
Tap turned off.
Watering not initiated. Control knob turned to
"Frequency" or "ON / OFF".
Battery capacity too low
3 LEDs flash).
Data input / changes made
while the program was starting
or immediately before.
Tap turned off.
Battery flat after working The battery you inserted
for a short time. is not an alkaline battery.
If you have any other problems with your Water Timer, please contact GARDENA Service.
12
Remedy
v Insert a new alkaline
battery.
v Turn on tap.
v Turn the control knob to
"Run Time Minutes".
v Insert a new alkaline
battery.
v Input data or make changes
before or after the starting
times you have chosen.
v Turn on tap.
v Use an alkaline battery.

7. Putting Your Water Timer Out of Operation

Disposing of flat batteries : v Please return flat batteries to a GARDENA dealer or dispose of
them properly at your nearest recycling centre.
Only dispose of batteries when they are flat.
v Store your Water Timer in a dry place away from frost before
Storage / Wintering :
the first frost sets in.

8. Technical Data

Min. / max. operating pressure :
Flow medium :
Max. water temperature :
Number of program-controlled watering cycles
per day:
Watering cycles per week :
Watering time per program :
Battery:
Running time :
G
1 bar / 12 bar
Clean fresh water
40 °C
Up to 3
Every day, every 2nd, 3rd or 7th day
1, 3, 5, 7, 10, 15, 20, 25, 30, 45, 60, 75, 90,
120, 150 or 180 minutes
1 x 9 V alkali-manganese (alkaline)
type IEC 6LR61
Approx. 1 year
13