Gainsborough P285 Instructions For Use Manual

Set 4 Solar Pebble Lights
Item No:
P285
Instructions for Use
Please read and retain these instructions for future reference
Power Details:
1x 1.2V AA 500mAH Ni-MH rechargeable battery.
Please read this instruction manual thoroughly before starting and ensure you are familiar with the
operation of your new SET 4 SOLAR PEBBLE LIGHTS.
1. Set switch (located on the back of solar case) to "ON" position. Charge the solar product by
placing it under direct sunlight for at least 8 hours.
2. The light will work automatically. It will automatically charge under direct sunlight during the
daytime and illuminate at night.
ALWAYS POSITION THE SOLAR PANEL IN DIRECT SUNLIGHT
NOTE: To verify that the switch is correctly in the "ON" position, cover the solar panel with your hand and the light
should turn on automatically.
IMPORTANT:
1.Install the solar product in an area where it can get direct sunlight.
2.Leave the switch to "ON" position.
3.Select an outdoor location away from other light sources at night, such as streetlights. It may cause the product not to
turn on automatically at night.
4.Duration of light depends on solar product's level of sunlight exposure, geographical locations, weather conditions
and the hours of daylight.
MAINTENANCE AND TROUBLESHOOTING:
1.Make sure the switch is set to "ON" position.
2.Keep the solar panel clean.
3.If solar product does not light up after it has been used for around 8 – 12 months, replace the rechargeable batteries as
they may be weak or worn out. (Battery 1 pc "AA" 1.2v 500Mah, Ni-MH, Rechargeable– Same equivalent type as
recommended must be used).
4.Battery replacement:
Step1: Unscrew the battery compartment cover by using a Phillips head screwdriver (not included) .
Step2: Remove the exhausted battery and install 1 pc new AA rechargeable battery according to the +/- polarity as
beside image. Open the compartment carefully and ensure that welding wires inside the battery terminals are not
damaged.
Step3: Replace battery compartment cover, screw it back into position and make sure is properly sealed.
v001: 24/09/24
ENGLISH INSTRUCTIONS