Gainsborough Solar Lying Angel Assembly Instructions/Instructions For Use

Solar Lying Angel
K224
v001: 08/12/21
Please read and retain these instructions for future reference
ASSEMBLY INSTRUCTIONS / INSTRUCTIONS FOR USE:
Unpack the components carefully. Please check all parts have been removed from the packaging.
OPERATION
FOR FIRST TIME USE:
Step 1:
Fully charge the battery before first use. Charge under direct sunlight in the <ON> position for 2 days.
Step 2:
Once the batteries are fully charged, set the ON/OFF switch to ON. If the lamp does not turn on after dark
refer to Maintenance section.
Your solar light will automatically turn on once it gets dark.
Find an ideal Place for the Solar Light.
Place the solar light in an area where it will receive direct sunlight for at least 8
hours per day. The solar panel is located on the back side of the angle. The
number of hours the light will illuminate is directly proportional to the hours of
sunlight it receives. If the light is placed in a shaded area, it will not be able to fully
charge and its illumination time will be limited. Do not place the light near other
outdoor lighting like porch or streetlights. These may fool the sensor and keep the
light from coming on, or cause it to turn off automatically.
Dimensions
(H) 14 x (W) 26 x (D) 11cm
Material: 90% Polyresin, 10% Plastic
•
PEACEFUL SLEEPING ANGEL WITH 3 WARM WHITE LED'S
AROUND HER HEADBAND THAT AUTOMATICALLY
ILLUMINATE AT DUSK (LEDs not replaceable)
•
MADE TO LOOK LIKE STONE BUT MADE OUT OF
WEATHERPROOF POLYRESIN
•
BUILT IN DISCREET SOLAR PANEL
ALWAYS POSITION IN DIRECT SUNLIGHT