Advertisement
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for imovr Q
Summary of Contents for imovr Q
- Page 1 Q Standing Desk System Assembly Instructions and User Manual...
-
Page 2: Before You Begin
Please review this manual before beginning the assembly of so be sure to lay the desktop on a soft, clean surface that your iMovR Q Standing Desk. This will help you save time won’t damage its beautiful finish. during the assembly process. - Page 3 Assembly Instructions Place your desktop upside-down onto a soft surface. The Align the desk frame bars, 2×short [B] & 2×long [C], with pilot holes for attaching the desk frame should be facing up. the edges of the desktop. All cable routing access openings and labels should face toward the center of the desktop.
- Page 4 Align power supply [D] with the pilot holes at the back of the desk, and secure it to the desktop with 2×wood screws [I]. Plug 2×leg motor cables [K] into two of the 4-pin ports on the power supply [D]. We recommend using the two ports clos- est to the desk frame.
- Page 5 Take care that the handset is properly aligned (the ▲ and ▼ keys should be on the right side). Adjust the leveling pads at the base of each desk leg [A] Basic Q Desk Operation until the desktop is level and doesn’t wobble. Leveling your ▲...
- Page 6 Handset Reset Procedure Adjusting the Desktop to a Memory Position Most errors with the Q Desk occur when a button on the Press and hold the desired Memory Position Key (1 or 2). handset is pressed during calibration. Such errors can be 2.
-
Page 7: Intended Use
Usage outside of the intended use for the Q Desk could lead to Electrical Safety minor injuries, serious injuries, or even death. The iMovR Q Desk is an electrical device, and basic safety precautions must be taken at all times. -
Page 8: Troubleshooting
Release all keys and wait for 5 seconds. Then, try again. Strain Gauge is defective Release all keys and wait for 5 seconds. Then, try again. Contact iMovR if problem persists. Do not operate the desk if components are broken. Error during pairing sequence Unplug the desk.
Need help?
Do you have a question about the Q and is the answer not in the manual?
Questions and answers