Subscribe to Our Youtube Channel
Related Manuals for LOGICDATA OPTIMUS Program 2-LEG
Summary of Contents for LOGICDATA OPTIMUS Program 2-LEG
- Page 1 OPTIMUS Program 2-LEG DYNAMIC MOTION System ASSEMBLY INSTRUCTIONS Document Version 4.0 / February 2025...
- Page 2 x2(4) *If there are no pre-drilled holes in the tabletop, use screw e wherever screw e is indicated. Document Version 4.0 / February 2025...
- Page 3 Document Version 4.0 / February 2025...
- Page 4 Document Version 4.0 / February 2025...
- Page 5 15 ± 1 Nm Document Version 4.0 / February 2025...
- Page 6 NOTE: For table top size 1400 mm do step 9 before step 8. Document Version 4.0 / February 2025...
- Page 7 Push excess cables into the traverses Document Version 4.0 / February 2025...
- Page 8 *1 Don’t fasten fully *2 Move to find 2 plastic part Document Version 4.0 / February 2025...
- Page 9 Document Version 4.0 / February 2025...
- Page 10 Perform END POSITION RESET Press and hold DOWN key until table stops at lower position limit Release DOWN key Press and hold DOWN key Table moves down slightly, then up again Release DOWN key Document Version 4.0 / February 2025...
Need help?
Do you have a question about the OPTIMUS Program 2-LEG and is the answer not in the manual?
Questions and answers