KI Trek & DataLink Multipurpose Quick Release Modesty Panel Assembly Instructions

February, 2002
KI
1330 Bellevue Street
P.O. Box 8100
Green Bay, Wisconsin 54308-8100
TEL (920) 468-8100
FAX (920) 468-0280
Assembly Instructions
™
Trek & DataLink ® Multipurpose
"Quick Release" Modesty Panel
Figure 1
#10 x
L-hanger
Figure 2
OPERATING INSTRUCTIONS
Figure 1
hanger
bracket
#10 x 1"
screw
⁄ "
3
4
screw
modesty
panel
engagement
pin
Figure 2
Last order date: 3-31-25
Last ship date: 6-30-25
Tools required: #2 Phillips screwdriver
Note: All screws necessary are included.
No drilling required. All screw holes have
been pre-drilled.
1. Place table top upside-down on a
smooth clean surface so table top is
not damaged. Fasten hanger brackets
to the table using #10 x 1" screws
(Note: Four screws per bracket)
(Figure 1).
2. Fasten L-hangers to the modesty
panel using #10 x 3 ⁄ " screws
4
(Note: Two screws per bracket)
(Figure 2).
Screws shown actual size
#10 x 1"
#10 x 3 ⁄ "
4
Attaching Modesty Panel
1. Slide modesty panel L-hangers into
the hanger brackets. When mechanism
engages, you will hear a "click"
release
(Figure 1).
tab
Removing Modesty Panel
1. Stand in front of the modesty panel and
reach underneath the panel. Pull down
on the hanger bracket release tab while
simultaneously pulling the modesty
panel towards you. This releases the
engagement pin from the L-hanger
(Figure 2).
© 2002 Litho in USA Code KI-61269/KP202