Network Deployment - Vivotek FD8134V User Manual

Network Deployment

Setting up the Network Camera over the Internet
This section explains how to configure the Network Camera to an Internet
1. If you have external devices such as sensors and alarms, make the connection from the
general I/O terminal block�
2. Use the supplied RJ45 female/female coupler to connect the Network Camera to a switch.
Use a Category 5 Cross Cable when Network Camera is directly connected to PC�
3� Connect the power cable from the Network Camera to a power outlet�
There are several ways to set up the Network Camera over the
up the Network Camera behind a
to use PPPoE�
Internet connection via a router
Before setting up the Network Camera over the Internet, make sure you have a router and follow
the steps below�
1� Connect your Network Camera behind a router, the Internet environment is illustrated below�
Regarding how to obtain your IP address, please refer to Software Installation on page 10 for
details�
+ : Digital input
- : Digital input
1
3
router� The second way is to utilize a static
connection�
Ethernet Switch
2
Internet� The first way is to set
IP� The third way is
User's Manual - 7
VIVOTEK