The purpose of this manual is to assist owners and forwarded to and operators in maintaining and operating the , INC. at time of delivery. Worldlawn mower and deck. Please read it IMPORTANT: Any unauthorized modification, carefully; information and instructions furnished can alteration, or use of non-approved attachments help you achieve years of dependable service.
General Information Quick Reference Sheet Engine Torque Specs Blades 423029 14.25 High Lift Blade 603035 20” Blade Pulleys 423173 14.25 Mulch Blade 603055 20.25” Mulch Blade Belts Front Caster Bearings 353111 Deck Belt 423200 Tires Seat 353 094 353278 Seat Spindles Transmission 353127...
Page 5
Any Mower or part thereof which, in Worldlawn’s sole discretion, is deemed defective shall be repaired or replaced, at Worldlawn’s option, without charge for parts or labor up to three years of the original date of purchase. Any Mower deck shell or part thereof which, in Worldlawn’s sole discretion, is deemed defective shall be repaired or replaced, at Worldlawn’s option,...
Page 6
ALWAYS WAIT at least changing direction on slopes. five minutes before refueling and REFUEL WITH THE ENGINE OFF. KEEP FUEL AWAY 17. This WORLDLAWN mower is NOT designed FROM SPARKS OR FLAMES. WIPE AWAY for towing. any fuel spillage BEFORE starting unit. Never fill the fuel tank indoors.
Before Operatng - STARTING ENGINE Remnders The throttle control, ignition switch and choke control are located between the motion control levers on the Check oil level. The engine is shipped with oil from the front panel under the front of the seat. factory.
Safety Interlock System that is designed to help FORWARD OR REVERSE prevent possible serious injuries. Understanding and maintaining this system is vital, for maximum This Worldlawn Mower is equipped with a pump/wheel safe operation. motor unit for each wheel and are controlled with TO START ENGINE: “Motion Control Levers”...
SER VICE LOCATOR Front Caster Wheel Bearings (2) CHAR T Front Caster Pivot Bearing Zerks (2) Engine Oil Fill & Dipstick Hour Meter Engine Air Filter Engine Oil Filter Fuel Tank Engine Fuel Filter Fuel Shut-off Valve Fuel Tank w/ Cup Holder Hydraulic Bypass Engine Vent Screen Drive Tires...
Clean air intake screen See Note A Clean cylinder / head fins See Note A Since the hydraulic drives on the Worldlawn mower are Clean foam element See Note A lifetime lubricated there are no required filter and or oil...
Belt Adjustment Deck Heght Adjustment Remove key from the ignition switch. The blade drive belt may be accessed by removing belt shields. Spring tension should be maintained by having Blade Drive Belt TO FRONT OF MOWER Tensioner Eyebolt Blade Drive Belt 353111 DECK BELT ROUTING Simplied View...
Mower Blades DECK LEVELING Check sharpness of mower blades after every 10 hours ADJUSTMENT of operation. To sharpen blades proceed as follows: Before checking the deck level make sure that tire CAUTION: pressures are at the proper level. Begin by setting the deck to a fixed position and pointing the blades to the front edge of the deck.
Page 13
WORLDLAWN PART # 353132 WIRE HARNESS FOR WYZ34K20 KAWASAKI FS600V BLACK 18 GA. LT. BLUE/RED 18 GA. LT. BLUE 14 GA. LT. BLUE/RED 18 GA. PURPLE 18 GA. YEL / LT. BLUE 18 GA. LT. GREEN 18 GA. WHT / LT. GREEN 18 GA.
Need help?
Do you have a question about the WYZ34K20 and is the answer not in the manual?
Questions and answers