Page 1
Operator’s Manual WY28X WY32X Commercial Mower Worldlawn Power Equipment, Inc. 401 N. Commerce Street, Beatrice, NE 68310 Toll Free Number: 1-800-267-4255...
Page 4
This manual contains assembly, operating, maintenance, adjustment, and safety instructions for your WY28X/WY32X lawnmower. Before operating your mower, read this manual in its entirety carefully. By following the operating, maintenance, adjustment, and safety instructions, you will prolong the life of your mower, maintain its maximum efficiency, and promote safe operation..
Only use accessories and in this manual and on the machine to identify attachments approved by Worldlawn Power Equipment, Inc. important safety messages which must be followed to avoid accidents. This symbol means: 1.3.2 The use of personal protective equipment,...
Page 8
HOW TO AVOID THE HAZARD · Purchase and store gasoline only in an approved container. POTENTIAL HAZARD · Always place gasoline containers on the ground · In certain conditions gasoline is extremely away from your vehicle while filling. flammable and highly explosive. ·...
1.4 OPERATION 1.4.1 Give complete, undivided attention to the job at Although hazard control and accident prevention hand. partially are dependent upon the design and 1.4.2 Mow only in daylight or good artificial light; configuration of the equipment, these factors are also keep away from holes and hidden hazards.
⚫ Watch for ditches, holes, rocks, dips, and rises 1.4.14 DO NOT mow with the discharge deflector that change the operating angle, as rough terrain raised, removed, or altered unless there is a grass could overturn the machine. collection system or mulch kit in place and working ⚫...
1.6.4 New safety decals may be obtained from your authorized equipment dealer or distributor or from Worldlawn Power Equipment, Inc. 1.6.5 Safety decals may be affixed by peeling off the backing to expose the adhesive surface. Apply only to clean, dry surface.
2.7 Accessories: and moving throttle lever to the rear will decrease engine speed. Some recoil starter a) Grass catcher assembly (2832200): 80L, see FIG 2 models are not equipped with key switch. Move b) Mulching Assembly (2832010/3210135): See FIG the throttle lever to the rearmost position, then the engine will kill.
40-52ft-lb (55-70 N-m) 3. ASSEMBLY INSTRUCTIONS 3.1 Unpacking Open the crate. Remove the loose parts (i.e., operator’s manual, etc) from crate. Remove unit from crate; check there are no loose parts left. 3.2 Assembling Instructions ⚫ Unfold the handle, and fix the handle with four M10×25 Flange Hd.
⚫ Refer to Maintenance, Section 5, and perform all Stopping the blades: Set the throttle to the “midway″ necessary inspection and maintenance steps. ⚫ Check tire pressure in drive wheels. Proper position, pull the mower blade drive lever backward to the “disengage” position to inflation pressure for tires is 30psi (210kpa).
dipstick or over the "FULL" mark. MAINTENANCE&ADJUSTMENTS 5.1.2 Clean Engine Air Cooling System. Service Interval: Daily or more often in dry conditions ⚫ Stop engine, wait for all moving parts to stop, and remove the key. POTENTIAL HAZARD ⚫ · While maintenance or adjustments are being made, Clean all debris from rotating engine air intake screen and from around engine shrouding.
Contact your authorized WORLDLAWN POWER EQUIPMENT SERVICE DEALER. It is essential that operator safety mechanisms connected and in proper operating condition prior to use for mowing. 5.1.6 Check for loose hardware. Service Interval: Daily ⚫ Stop engine, wait for all moving parts to stop, and remove key.
5.2 ADJUSTMENTS recommended in engine owner’s manual. DO NOT overfill. IMPORTANT: Disengage PTO, shut off engine, wait ⚫ Start the engine and check for leaks. Stop engine for all moving parts to stop, and remove key before and recheck oil level. servicing, cleaning, or making adjustments to the unit.
deflection is 7-9mm ) (See FIG 9) 5.2.3 Transmission Drive Belt Adjustment. ⚫ 5.2.2.1 Synchronous Belt Adjustment & Replacement Stop engine, wait for all moving parts to stop, ⚫ Stop engine, wait for all moving parts to stop, and remove key or pull out spark plug lead. ⚫...
⚫ Adjusting the brake force: Lift the left / right 5.2.6 Transmission case replacement ⚫ shift rod and lock it by the buckle. Rotate nut 1 Stop engine, wait for all moving parts to stop, and nut 2 of the brake lever, so as to compress and remove key or pull out spark plug lead.
change rod length, remove cotter pin from upper 6. TROUBLESHOOTING Shift Control Rod Assembly. Remove rod from 6. TROUBLESHOOTING lever bracket hole. Rotate rod until desired length is achieved to cause switch to compress correctly. 6.1 MOWER PULLS LEFT OR RIGHT Reinstall rod into lever bracket hole and add Check air pressure in tires, 30PSI(210kPa).
ENGINE TROUBLESHOOTING TABLE Will not start POTENTIAL HAZARD Hard starting ·Charging the battery may produce explosive gasses. Stops WHAT CAN HAPPEN suddenly ·Battery gasses can explode causing serious injury. Lacks power HOW TO AVOID THE HAZARD ·Keep sparks, flames, or cigarettes away from battery. Operates ·Ventilate when charging or using battery in an erratically...
Page 23
POTENTIAL HAZARD · Battery contains sulfuric acid. Avoid contact and ·If the ignition is in the “ON” position, there is a always shield eyes, face, skin, and clothing from potential for sparks and engagement of components. battery. Cigarettes, flames, or sparks could cause WHAT CAN HAPPEN battery to explode ·Sparks could cause an explosion or moving parts...
Worldlawn’s liability (as set forth ARISING OUT OF ANY CAUSE WHATSOEVER, below). WHETHER BASED IN CONTRACT, Any Mower or part thereof which, in Worldlawn’s sole NEGLIGENCE OR OTHER TORT, discretion, is deemed defective shall be repaired or STRICTLIABILITY, BREACH OF WARRANTY OR replaced, at Worldlawn’s option, without charge for parts...
Page 28
Worldlawn Power Equipment, Inc 401N. Commerce Street, Beatrice, NE 68310 Phone: (402) 228-4255 Fax: (402) 223-4103 www.worldlawn.com Form No. 28202-201807...