Download Print this page

audium Comp 3.2 Active User Manual page 6

Advertisement

Handling, Cleaning and Care
For cleaning, use a soft dry or slightly damp cloth.
Please avoid aggressive cleaning agents as well as special furniture polishes or any other
cleaning fluids. Dust from the chassis can be removed gently by using a tiny furniture
brush.
Warning:
Avoid touching the chassis and membranes!
They are very sensitive and can be easily damaged!
Unpacking and setting up the speakers
The AUDIUM speakers are delivered in separate cartons. Alter opening them, remove the
polyfoam protection elements and the textile bag. Do not dispose the packaging - you can
carry the speakers in a save way only when using the original packaging.
Spikes
AUDIUM floor speakers radiate sound best when the front battle is inclined for a few
degrees. Therefor screw the front spikes for 5mm, the rear spikes totally into the
designated winding-drills. Take care that the speaker has a steady position.
Finally, tighten the spikes with the appropriate screw nuts.
Further information on the installation below in the chapter "Installation".
Note: To protect wooden floors, we recommend the use of washers, which you can get
from your dealer. Alternatively, you can also use any metal discs for bridging.
Dust-Caps
The loudspeakers are equipped with dust-caps per default. These are simply attached
to the speaker front and can be removed with low force through pulling them oft, it you
desire.
Even though these dust-caps have been designed according to acoustic aspects, the best
sound performance can be achieved when they are removed from the
loudspeakers.
Plugs in the bass reflex tube
The bass reflex tubes are sealed with a semi-permeable foam
stopper. Do not remove this to change the bass response. The
tuning of the speakers is chosen so that you achieve the
maximum tonal performance with these plugs. If you want to
boost bass, you can do so by using the Bass setting in the
Speaker Setup.
- 6 -

Advertisement

loading
Need help?

Need help?

Do you have a question about the Comp 3.2 Active and is the answer not in the manual?