Download Print this page

audium Comp 3.2 Active User Manual page 14

Advertisement

Muting and locking the speaker:
Mute the speaker
:
If you press the rotary knob briefly while the status is displayed, the loudspeaker is muted.
So you can simply stop the playback to plug or unplug the RCA cable without causing loud
hum or drone noises.
Press again to unmute the speakers. This also happens automatically after 10 seconds
(this value can be changed in the Setting menu).
Locking the speaker:
To prevent unwanted changes to the parameters, you can lock the speaker. Press and hold
the knob while the display shows the speaker status. The Operation is then disabled (and
thus prevent the creation of settings by your children!). To unlock, press and hold the knob
again.
If the speaker is disconnected from the mains, the lock is released.
Muted
Unmuted
Locked
Unlocked
Automatic switching on and off
The speakers have integrated music signal detection. If no music is played back,
the Speaker goes to standby after 15 minutes (this value can be changed in the Settings
menu). If music signal is detected, then the Speaker switch back on automatically.
Note:
If you are the Disconnecting speakers from the mains you have nothing to note. Restarting
/ plugging brings your speakers back to their last state. All parameters (except the lock -
see above) are stored in a long-term memory that does not lose its contents.
The Settings
Navigation through the menu is easy: turn the knob while the status is displayed to open
the settings menu.
Navigate through the menu by turning the knob. When you have found the setting you
want to change, press the knob, and then change the value.
Press again the button to save the value.
You enter submenus by pushing the knob, and exit them by selecting:
The menu is automatically exited after a certain time
- 14 -

Advertisement

loading
Need help?

Need help?

Do you have a question about the Comp 3.2 Active and is the answer not in the manual?