Advertisement

Owners Manual &
Operating Instructions
MODEL:YCD226

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the YCD226 and is the answer not in the manual?

Questions and answers

Summary of Contents for Isotherm YCD226

  • Page 1 Owners Manual & Operating Instructions MODEL:YCD226...
  • Page 2: Safety Information

    SAFETY INFORMATION NOTICE Please read the user manual and safety instructions carefully before using the appliance. ◆ By ignoring the safety instructions, the manufacturer cannot be held responsible for the damage. ◆ The use of accessories that are not recommended by manufacturer can cause injuries and will invalidate any warranty that you may have.
  • Page 3 WARNING! ● Do not store explosive items, such as aerosol cans with a flammable propellant in this appliance. ● Risk of fire and electrical shock. ● Do not let hot items touch the plastic parts of the appliance. ● Do not put flammable products or items in, near or on the appliance. ●...
  • Page 4 REFRIGERANT SAFETY INFORMATION SAFETY INFORMATION Correct functioning of this product depends on a small amount of refrigerant gas contained within a NOTICE hermetically sealed system. Check the type of gas contained in your product. Please read the user manual and safety instructions carefully before using the appliance. The type of gas is indicated on the identification plate and in chapter SPECIFICATIONS.
  • Page 5 DANGER: HANDLING THE REFRIGERANT CIRCUIT The gas is contained in a hermetically sealed system, which is essential for correct operation of the ◆ product. Prevent hot objects from coming into contact with the plastic parts of the product. ◆ Do not open the refrigerant circuit for any reason. ◆...
  • Page 6: Installation

    Bushman immediately. INSTALLATION Installation of the YCD226 must be completed by a suitably trained professional only. WIRING Always wire your fridge directly to your battery terminals. Do not run the wires via a buss bar, battery management system or shared circuit.
  • Page 7: Specifications

    The vents should be located at the bottom and top of the fridge cavity and have a free cross section ofminimum 600cm2 each. Note that a 500mm x 250mm vent will have only a free cross section of approximately600 cm2 (not 1250 cm2). SPECIFICATIONS MODE YCD226 Dimensions (L x W xH) 595x575x1460mm Capacity 226L...
  • Page 8: Operation

    OPERATION 1. ON/OFF Button When power-on, short press the “ ” button, the system enters the standby mode; In the standby mode, short press the “ ”button, the system enters the power-on mode. 2.Temperature setting ● In the power on state,press " + " or " - " key to adjust the temperature. ●...
  • Page 9 DAILY MAINTENANCE AND ATTENTION Matters need attention ● Please use a wet cloth and warm water mixed with gentle non-abrasive detergents to clean the interior and exterior of your fridge. ● Please power off and unplug the unit before cleaning. ●...

Table of Contents