Numark MIXSTREAM PRO User Manual page 7

13. FX Select: Press these buttons to enable or disable the
selected effect: Echo, Delay, Flanger or Phaser.
14. Effects Toggle: Move this toggle switch away from you to
activate the selected effect—the toggle will latch to that
position. Pull the toggle back to the center position to
deactivate the effects.
Pull and hold this toggle toward you to activate the selected
effect momentarily, and release the toggle to deactivate the
effect—the toggle will return to the center position.
15. Channel Fader: Use this fader to adjust the channel's volume
level.
16. Crossfader: Use the crossfader to mix between Deck 1 and
Deck 2.
17. Main Level Meters: These LEDs display the audio signal level
of the main mix (sent out of the Main Outputs).
18. Headphone Preview: Press this button to preview the
channel in the headphones. Use the Headphone Mix knob to
adjust the mix between the channel's pre-fader signal and the
headphones' cue channel.
19. Headphone Mix: Turn this knob to adjust the blend of the
headphone cue and main channels together in the headphones.
20. Headphone Volume: Adjusts the volume for headphone
cueing.
21. Platter: This capacitive, touch-sensitive platter controls the
audio playhead when the wheel is touched and moved.
22. Smart Scratch: When this button is enabled, Smart Scratch
mode will be active. In this mode, the track's timeline
continues (the lower half of the waveform in the display will
continue moving forward) when you use the platter to
"scratch" the track. When you release the platter, the track will
resume normal playback from where it would have been if you
had never moved the platter.
When Smart Scratch is enabled, press and hold Shift and press
this button to enable jog mode. In this mode, touch the platter
and move it to temporarily adjust the track's speed.
Press this button again to disable Smart Scratch and enable
vinyl mode for the platter. You can use the platter to
"scratch" the track as you would with a vinyl record.
Note: Smart Scratch is enabled by default and can be
adjusted in the Settings
Press and hold Smart Scratch to enter/exit Grid Edit Mode.
menu.
7