Download Print this page

Override Set Temperature - Systems Controls & Instruments ETN-24-PROG Series Owner's Manual

Advertisement

DURING THE PROGRAM THE UNIT WILL NOT CHANGE TO NORMAL DISPLAY UNTIL
ALL THE PROGRAM HAS BEEN REVIEW.
AT ANY TIME DURING THE PROGRAMMING YOU CAN REVIEW QUICKLY THE SETTINGS BY
PRESSING THE "ON" BUTTON.

5.5. OVERRIDE SET TEMPERATURE:

At anytime you may change the temperature by pressing the set
buttons. The new temperature will be retained until the next prog
start. If the thermostat was in prog mode, then the number
of the prog. will disappear until the next prog.
THE THERMOSTAT MEMORY (PROGRAM) WILL HOLD FOR 24 HOURS DURING POWER FAILURE
5.6 Back Light
The back-light of the unit will activate when a button is pressed or the information is send from the remote control.
6. RT04 - Hand held remote control - (option for FMT-PROG SERIES)
General
This remote control is Infrared, the remote must be pointed at the thermostat
to operate. Every time you change a parameter in the Remote Control,
you must send it to the thermostat by pressing "ON/SEND" .
Every time that the information is sent to the thermostat, the Back Light will
switch ON.
Operating Manual
Fan:
Press FAN button to change between: FAN ON (
Press ON/SEND button to send information to the thermostat.
Mode:
Press MODE button to change between: COOL, HEAT, AUTO CHANGE and
FAN ONLY.
Press ON/SEND button to send information to the thermostat.
Set Temperature:
Cool Mode: Press the set buttons (+) or (-). COOL & digits will flash, select the
desired temperature. Press ON/SEND button to send information to the thermostat.
Heat Mode: press the set buttons (+) or (-). HEAT & digits will flash, select the
desired temperature. Press ON/SEND button to send information to the thermostat.
Auto Change Mode: Press the set buttons (+) or (-) COOL and SET
TEMPERATURE will flash, set cooling with (+) or (-) buttons.
File: ETN-24-PROG book - page letter
) or AUTO FAN (A).
Rev: 1
- 10 -
Pipersville, PA 18947 USA
Phone: 215-766 1487 Fax: 215-766 1493
Email: info@scillc.com - www.scillc.com
Date: 24-06-2002

Advertisement

loading
Need help?

Need help?

Do you have a question about the ETN-24-PROG Series and is the answer not in the manual?

Subscribe to Our Youtube Channel

This manual is also suitable for:

Etn24-hp21-2s-fp-prog-f