Texas Instruments TI-89 Manual Book page 135

Moving from
Function to
Function
Automatic Panning
Note: Automatic panning
does not work if stat plots
are displayed or if a function
uses a shaded display style.
Using QuickCenter
Tip: You can use
QuickCenter at any time
during a trace, even when
the cursor is still on the
screen.
Canceling Trace
118 Chapter 6: Basic Function Graphing
Press C or D to move to the previous or next selected function at
the same value. The new function number is shown on the screen.
x
The "previous or next" function is based on the order of the selected
functions in the Y= Editor, not the appearance of the functions as
graphed on the screen.
If you trace a function off the left or right edge of the screen, the
viewing window automatically pans to the left or right. There is a
slight pause while the new portion of the graph is drawn.
Before automatic pan
After an automatic pan, the cursor continues tracing.
If you trace a function off the top or bottom of the viewing window,
you can press ¸ to center the viewing window on the cursor
location.
Before using QuickCenter
After , the cursor stops tracing. If you want to continue
QuickCenter
tracing, press ....
To cancel a trace at any time, press N.
A trace is also canceled when you display another application screen
such as the Y= Editor. When you return to the Graph screen and
press ... to begin tracing:
¦
If Smart Graph regraphed the screen, the cursor appears at the
middle value.
x
¦
If Smart Graph does not regraph the screen, the cursor appears at
its previous location (before you displayed the other application).
After automatic pan
After using QuickCenter