Robolink codrone EDU User Manual page 9

Pairing
Your new drone and controller are already paired out of the box. If you want to pair
the controller to another drone, you can pair by following these steps.
How to pair
Please note, the drone and controller only need to be paired once. Once paired, they
will pair automatically when powered on and within range.
1
Put drone in pairing mode
Insert a battery into the drone. Press and
hold the pairing button on the bottom of
the drone until the drone LED is flashing
yellow.
2
Press and hold P
Power on the controller. Make sure you aren't in the
LINK state (see page 12), if your controller is connected
to a computer. Press and hold the P button until you
hear a chime.
3
Verify that you're paired
You should hear a chime, and the lights on the drone and controller should turn solid.
You should see a symbol on the screen.
front
Bottom view flashing yellow
14
Verify that you are paired by
pressing R1 a few times. The colors
of the drone and controller should
change together.
If the LED on your drone is flashing
red and the controller screen says
"Searching...", your drone and
controller are not paired.
Basic Flight Commands
Here are a set of common commands you can use with the controller to pilot the
drone.
Taking off, landing, stopping, and changing speed
Take off
Press and hold L1 for 3 seconds.
The drone will take off and hover at
about 70-90 cm above ground.
Paired! Not paired
SEARCHING. . .
solid color flashing red
Land
During flight, press and hold L1
for 3 seconds.
15