Firstech DC3 Master Manual page 8

RPS (Remote Paging Sensor) Programming Your Code (continued)
2 Way LCD remote paging
To page a 2 Way LCD remote just tap the 'Red Circle' twice.
Touch Panel Sensitivity
To change touch sensitivity open the driver's door, hold the button on the back of the RPS Touch until the LEDs go out. Release button and
tap again. The number of solid LEDs represent sensitivity of touch, 1 being the lowest, 5 the highest.
RPS Touch On or Off
You can turn the RPS Touch off from your remote. Just follow the instructions below:
STEP 1: Enter remote programming mode by holding down buttons 2+3 (Trunk and Key/Start
buttons on 2W901R-SS) simultaneously for 2.5 seconds. The remote will beep once and the LCD or read "REMOTE MENU"
indicating that you have entered programming mode.
STEP 2: Scroll through the remote options by taping button 3 or 4 (Function button 2W901R-SS).
Once the LCD RPS icon flashes reads "RPS-ON" tap button 1 or (Lock button 2W901R-SS) to turn this feature on. The LCD will
read "RPS-OFF"
STEP 3: Exit remote programming by holding down buttons 2+3 (Trunk and Key/Start 2W901R-SS)
buttons simultaneously for 2.5 seconds. The remote will beep indicating that you have successfully exited programming.
U.S. Patent No. 8,856,780 CA 2759622
Automotive Data Solutions Inc. © 2023
Component Use & Placement
Page 8
20250402