Firstech DC3 Master Manual page 7

IMPORTANT: The placement and use of components are critical to the performance of this system.
Antenna and Cable
Firstech antennas are calibrated for horizontal installation at the top of the windshield. The cable that connects the antenna to the control
module must be free from any pinches or kinks. Installing the antenna in areas other than the windshield may adversely affect the effective
transmitting distance of the remotes.
RPS Touch and RPS (Remote Paging Sensor)
The RPS is an optional feature. The car call/RPS feature uses a small sensor that is mounted on the inside of your windshield.
1. RPS Touch (Remote Paging Sensor)
The new RPS touch has multiple features including: remote paging, 4 digit pin unlock/disarm, and arm/lock. All features are operated with a
simple touch of the sensor.
RPS Touch and car call functions do not require programming, however in order to unlock/disarm your vehicle you must program a 4 digit
passcode (numbers 1 through 10 only) you can view our video library for programming instructions at: www.myfirstech.com
RPS (Remote Paging Sensor) Programming Your Code
STEP 1: Choose your RPS Touch 4 digit code. '0' is not available.
STEP 2: Turn ignition to the 'ON' position and leave driver's door open.
STEP 3: Hold your finger over the 'Red Circle' icon for 3 seconds.
STEP 4: When the siren chirps and LEDs flash in a circular pattern, tap on your first number. (Hold the
number for 2.5 seconds to choose 6 through 10.) After choosing your first number you will get one siren chirp and LEDs will
flash in a circular pattern.
STEP 5: Repeat Step 4 until all four digits are set. You will get 1 siren chirp and 1 parking light flash.
Repeat Steps 2 - 5 if you get 3 chirps and light flashes. Your RPS Touch is now programmed.
Alarm rearm and lock
To rearm hold your finger on the 'Red Circle' for 3 seconds.
Alarm disarm and unlock
To disarm hold your finger over the 'Red Circle' for 3 seconds. Once the LEDs start their circular pattern, enter your 4 digit code by touching
the window with the flat part of the tip of any finger over the number for each digit of your code. (Refer to Step 4 above or training video at
www.myfirstech.com) Two seconds after entering the 4th digit, your system will first re-arm/lock. In two seconds, it will disarm/unlock.
U.S. Patent No. 8,856,780 CA 2759622
Automotive Data Solutions Inc. © 2023
Component Use & Placement
Page 7
20250402