Firstech DC3 Master Manual page 5

NOTE:
- The module must be flashed, successfully
programmed and in an unlocked/disarmed
state to enter remote programming.
- Programming will only work with a
LOCK command. If using a 1-button
remote, make sure not to double-tap
(unlock) or hold (remote start) the
button, or it will NOT learn.
ALTERNATE REMOTE PROGRAMMING
PROCEDURE 2
PTS (Push to Start) application
STEP 1: Set the vehicle to the ignition or
"ON" position
STEP 2: Within 5 seconds push to the
"OFF" position
STEP 3: Within 5 seconds set the
vehicle to the ignition or "ON" position
(do not start)
STEP 4: Step on the foot brake 3 times
within 5 seconds. The parking lights
will flash 1 time to indicate remote
programming is enabled
STEP 5: Tap (a quick 0.5 second press
and release) the lock button on the
remote. The parking lights will flash 1
time indicating remote code has been
accepted
STEP 7: After 5 seconds of no valid
remote codes being transmitted the HC
will automatically exit programming
mode
U.S. Patent No. 8,856,780 CA 2759622
Automotive Data Solutions Inc. © 2023
Remote Programming Procedure
>>
WARNING: Program aftermarket remotes
before usage. A maximum of four [4x]
aftermarket remotes per system.
01
Time restriction. Complete next step within 7
seconds.
02
Cycle ignition ON fi ve times [5x OFF/ON]
rapidly.
OFF ACC ON START ON
ENGINE
START
STOP
03
Parking Light will fl ash once [1x].
04
Time restriction. Complete next step within 5
seconds from previous step.
05
Press once [1x] on LOCK button of aftermarket
remote.
06
Parking Light will fl ash once [1x].
>>
To program additional remotes: repeat steps 4
to 6 using each additional remote.
07
Wait, Parking Light will fl ash twice [2x].
08
Turn ignition to OFF position.
OFF OFF ACC ON START
ENGINE
START
STOP
09
Aftermarket Remote Programming Procedure
completed.
Page 5
20250402