Firstech FTI-FDK1- Type 2A1 Vehicle Coverage & Preparation Notes

FTI-FDK1- Type 2A1 - Vehicle Coverage & Preparation Notes
Make Model
DL-FM3
Ford Edge
Ford Explorer
Ford Taurus
Lincoln MKX
Hey! Read this stuff before you start the installation...
Firmware:
Covered vehicle uses BLADE-AL(DL)-FM3, flash module and update the controller firmware before installing.
Controller Configuration:
Set feature 1-11 to option 2 (Ignition pulse - same timing as disarm pulse) for proper handling of OEM alarm.
Install:
Type 2 vehicles require cutting the FM3 TX loop near the harness BLADE connector, cut loop before programming to vehicle.
Locks:
Type A locks at black 26-pin connector, Lock: Pin #6, blue/green, Unlock: Pin #8, yellow/violet.
RAP:
RAP handling, connect to driver door pin at black 26-pin BCM connector, pin#9, violet.
Auto-Lights (If equipped):
Lights (open): violet/green, pin #4 of headlight switch connector (open circuit, requires relay)
Lights-off ( - ): white/violet, pin #6 of headlight switch connector (light-off, ( - ) negative)
Okay, now get to work...
Year Install
2011-14 Type 2
2011-15 Type 2
2013-17 Type 2
2011-12 Type 2
Auto-Light Detail
white/violet
violet/green
87a
+12V
STATUS
Lights
CAN Locks
Park / Auto
OBD-II A A
OBD-II A A
OBD-II A A
OBD-II A A
E
1 4
9 10
30
87
FT-RLY-10A
SUPPORT - 1(888) 820-3690, EXT. 203
I/O Changes
Trunk
Green White / Blue
CM7000/7200 Cut loop for A/T
CM-900S/900AS
CM900AS/900S Jumper