Advertisement
6. For each SSD you wish to install, remove the associated mounting screw from the circuit
board. Then, align each M.2 SSD with its connector and slide the SSD forward until it is
fully seated. If the drive feels stuck, do not force it into the connector; remove it, re-align
the SSD's contacts with the connector and try again.
7. Each drive's mounting screw as shown. Repeat Steps 6 and 7 for each SSD being
installed. The image below-left shows what the device looks like with all four M.2 SSDs
installed. Note that you can use different brands and capacities of SSD if you wish.
Advertisement
Need help?
Do you have a question about the Express 4M2 and is the answer not in the manual?
Questions and answers