Advertisement
PSB No: P-0061
Page: 2 of 3
For example, if a document is being sent and is not detected by document sensor 2,
the PF1000 will go into error mode.
Simultaneously pressing and holding the
FINE/PHOTO and the START/COPY buttons until the buzzer stops sounding, sets the
PF1000 into an error code display mode.
In this error condition, when the "ADD
PAPER" LED is ON, only the "PHOTO" and "FINE" LEDs will be ON. In Table 1, This
is interpreted as a "1" for columns 0 and 1 and a "0" for columns 2 and 3. When the
"ADD PAPER" LED is OFF, only the "SEND DOCUMENT" and "FINE" LED's will be ON.
In Table 1, this is interpreted as a "1" for columns 5 and 7 and a "0" for columns 4
and 6. In Table 1, locate the Row that has a "1" in columns 0, 1, 5, and 7 and a "0"
in columns 2, 3, 4, and 6. Notice that this row corresponds to the same row that lists
the "Doc. sensor 2 not detecting document" error.
Advertisement
