Camera Operation
Operation is carried out by pressing the switch, or
shifting the gear lever.
The following settings may be required depending
on the connected navigation/monitor.
•
Rear camera connection: ON setting
Setting to ON is required to display the camera
image on the navigation/monitor.
•
Camera guidelines display: OFF setting
This camera system has its own, calibrated
guidelines. It is not necessary to display the
guidelines found in the navigation/monitor
system being used.
•
Refer also to the owner's manual of the product to
connect.
Turning the Rear Camera On
and Off
Displaying the rear image by
shifting the gear lever
1
Shift the gear lever to the reverse
position (backing up).
The video image behind the car and the
audible warnings depends upon the gear
shift position.
2
If you shift the gear lever to a position
other than reverse (backing up), the
monitor returns to the previous screen.
•
Refer also to the Owner's Manual of the connected
monitor/navigation system.
•
Be sure to also check behind and around the car
visually. Use the camera image to assist in showing
conditions behind and around the car.
•
Depending on where the unit is installed, actual
conditions may differ from the displayed image.
Displaying the rear image through
operation from connected products
e
Operation from IVA-D511 series
1
Press SOURCE/C on the unit.
VIEW
The SOURCE selection screen is displayed.
2
Touch [Camera].
SET.
The Camera mode is activated and the rear
view video is displayed.
3
Touch [Guide Off].
4
Touch [
screen, and then touch [Normal] to
return to previous main screen.
e
Operation from IVA-W520 series
1
Press VISUAL on the unit.
The VISUAL selection screen is displayed.
2
Touch [CAMERA].
The Camera mode is activated and the rear
view video is displayed.
3
Touch [ESC].
4
Touch [VISUAL] to access to Visual
selection screen, and then touch
[NORMAL] to return to previous main
screen.
e
Operation from iXA-W404 series
1
Press
The Camera mode is activated and the rear
view video is displayed.
Pressing again will return to Audio/Visual
mode.
e
Operation from iXA-W407BT
series
1
Press C SOURCE to activate mode
switching screen.
2
Slide the display horizontally with your
finger to select Camera mode.
] to access to Visual selection
(CAMERA).
15
-EN