Installing The Control Unit - Alpine HCE-C300R Owner's Manual

5. Installing the Control Unit

1
Attach the control unit B with the Velcro
fastener F or self-tapping screw G.
•
It is recommended to install the control unit on the
rear of the instrument panel, or under a seat.
e
Attaching with Velcro fastener
(1) Attach the Velcro fastener (hard side)
F to the bottom of the control unit B.
Control unit
Velcro fastener
• Attach the Velcro fastener in an area on the bottom
of the unit undersurface where the label is not
attached.
(2) Attach the Velcro fastener (soft side)
F to the floor, and secure the control
unit B.
When attaching the Velcro fastener (hard side) F
•
to the floor carpet, do so without the Velcro fastener
(soft side) F attached.
e
Attaching with the self-tapping screw
(1) Attaching the control unit with the
self-tapping screw G in a flat location.
Control unit
21
-EN