Table of Contents
Advertisement
Installation and
Connections
•
Be sure to disconnect the cable from the (–) battery post
before installing your HCE-C300R. This will reduce any
chance of damage to the unit in case of a short circuit.
•
Be sure to connect the colour coded leads according to
the diagram. Incorrect connections may cause the unit to
malfunction or damage to the vehicle's electrical system.
•
When making connections to the vehicle's electrical
system, be aware of the factory installed components (e.g.
on-board computer). Do not tap into these leads to provide
power for this unit. When connecting the HCE-C300R to
the fuse box, make sure the fuse for the intended circuit of
the HCE-C300R has the appropriate amperage. Failure to
do so may result in damage to the unit and/or the vehicle.
When in doubt, consult your Alpine dealer.
•
Route the cables and wiring away from hot or moving
parts, and fix them securely to avoid heat/mechanical
damage to the cable insulation, which may result in short-
circuit, fire or electric shock.
•
When fixing the control unit, camera, and alarm to the
vehicle with screws, attaching to weak spots may damage
vehicle parts.
•
If the camera is not mounted securely, shifting positions
will cause deterioration of detection performance.
•
The cable may break due to stress caused when opening
and closing the door/trunk of the vehicle.
•
If the control unit becomes wet, the electrical circuitry may
short out.
•
Attaching with double stick tape may leave a mark on the
vehicle interior.
•
This camera system is meant to be used as a rear camera. It
cannot be used as a front or side camera.
•
This camera system cannot be used as a corner sensor.
•
The camera is designed specifically for use with this
system. The system cannot be used with a different camera.
•
This product cannot be installed in or used with anything
other than a car (in other words, it cannot be used with
motorcycles, mobility vehicles, or electric wheelchairs or as
a household security camera, etc.).
Installation of the Rearview
Camera System
Installing the Rearview camera (page 18)
Installing the buzzer and operation switch
(page 20)
Checking the installation location of the
control unit (page 21)
Connect the device (page 22)
Perform calibration (page 26)
Fixing the control unit
Mounting the Rearview
Camera
1. Preparation
1
Check accessory parts.
A Rearview camera (50 cm) B Control unit
C Power cable
(Solderless connector)
E Camera extension cable
(8m)
G Self-Tapping screw
(Control unit)
(M4 × 8)
X4
I Angle adjustment screw
(Base for attaching the
camera) (M3 × 6)
X2
K Self-Tapping screw (Base
for attaching the camera)
(M3 × 8)
X4
D Monitor connector
extension cable (3 m)
F Velcro fastener
(Control unit)
H Mounting (Base for
attaching the camera)
J Hexagonal wrench
L Switch (3m)
17
-EN
Advertisement
Table of Contents
