Download Print this page

Chapter 7 Device Connection; Set Pc Network - HikRobot SC2000E Series Quick Start Manual

Hide thumbs Also See for SC2000E Series:

SC2000E (Mini) Series Vision Sensor Quick Start Guide

Chapter 7 Device Connection

Device connection to the client software is required for device's configuration and remote

operations. This section introduces how to install the client software, set PC and device

network, connect the device to the client software, etc.

To ensure stable image transmission and normal communication between the PC and the

device via client software, you need to set the PC network before using the client software.

Note

For different Windows versions, the specific setting path and interface may differ. Please

refer to the actual condition.

Steps

1. Go to PC network settings page: Start → Control Panel → Network and Internet →

Network and Sharing Center → Change adapter settings.

2. Select NIC and set the IP obtainment mode.

● Select Obtain an IP address automatically to get an IP address of the PC automatically.

● Or select Use the following IP address to set an IP address for the PC manually.

Figure 7-1 Set PC Network

3. Set NIC property.

Table of Contents

Do you have a question about the SC2000E Series and is the answer not in the manual?

Sc2000e mini