SC2000E (Mini) Series Vision Sensor Quick Start Guide
No.
Signal
GPIO3
Line 3+
10
GND
Line 0/1/2/3-
11
12
--
--
--
13
--
14
MDI0-
--
15
MDI1+
--
GPIO0
Line 0+
16
GPIO1
Line 1+
17
4.2 17-Pin M12 Cable
You should use the supplied 17-pin M12 cable to wire the device.
● The RJ45 connector corresponds to 6th, 7th, 14th, and 15th pins of the 17-pin interface.
● The DB9 serial port connector corresponds to 4th and 5th pins of the device's 17-pin
interface.
● The open line corresponds to 3rd, 12th, and 13th pins of the device's 17-pin interface.
Caution
The open lines of the supplied 17-pin cable cannot be wired with the SC2000E series
device.
I/O Signal
Source
Bi-directional I/O, and it is output
by default.
Direct current power supply
negative
--
--
Fast Ethernet signal MDI0-
Fast Ethernet signal MDI1+
Bi-directional I/O, and it is the
trigger by default.
Bi-directional I/O, and it is used to
switch projects by default.
Figure 4-2 17-Pin M12 Cable (RJ45 Connector)
Description
8
Supplied Cable
8-pin connector
8-pin connector
Pink open cable
Purple open
cable
RJ45 connector
RJ45 connector
8-pin connector
8-pin connector
Need help?
Do you have a question about the SC2000E Series and is the answer not in the manual?