BASIC CONNECTIONS
CONNECTING SPEAKER SYSTEMS
• Be sure to use speakers with the specified impedance as shown on the rear panel of this unit.
Note:
• To prevent damage to circuitry, do not let the bare speaker wires touch each other and do not let them touch any metal part of this
unit.
• Do not touch the speaker terminals when the power is on. It may cause you to receive an electric shocks.
• Do not connect two or more speaker cables to a speaker terminal at the same time. If you do so, this unit may be damaged.
• Be sure to connect the positive and negative cables for the speaker properly. If they are miss-connected, the signal phase will be
reversed and the signal quality will be corrupted.
SPEAKER SYSTEMS
SPEAKER IMPEDANCE : 4 - 8 OHMS
R CH
Set to "STEREO"
F.C.B.S.
BI.AMP
IN
STEREO
L CH
L CH speaker
OUT
R CH speaker
ENGLISH
9