Download Print this page

Simplex SWIFT-E Manual page 6

10kw-15kw load bank
Hide thumbs Also See for SWIFT-E:

Advertisement

1.0 WARNINGS AND CAUTIONS
Four commonly used safety symbols accompany the DANGER, WARNING, and CAUTION
blocks. The type of information each indicates is as follows:
Improper operation of this equipment such as neglecting its maintenance or
being careless can cause possible injury or death. Permit only responsible and
capable persons to install, operate, and/or maintain this equipment.
Potentially lethal voltages and amperages are present in these machines. Ensure
all steps are taken to render the machine safe before attempting to work on the
equipment.
• All hardware covered by this manual have dangerous electrical voltages and can
cause fatal electrical shock. Avoid contact with bare wires, terminals, connections,
etc., on the hardware, if applicable. Ensure all appropriate covers, guards, grounds,
and barriers are in place before operating the equipment. If work must be done
around an operating unit, stand on an insulated dry surface to reduce shock hazard.
• Do not handle any kind of electrical device while standing in water, while barefoot, or
while hands or feet are wet. DANGEROUS ELECTRICAL SHOCK MAY RESULT.
• If trained personnel must stand on metal or concrete while installing, servicing, ad-
justing, or repairing this equipment, place insulative mats over a dry wooden plat-
form. Work on the equipment only while standing on such insulative mats.
• The National Electrical Code (NEC), Article 250 requires the frame of the equipment
to be connected to an approved earth ground and/or grounding rods. This grounding
will help prevent dangerous electrical shock that might be caused by a ground fault
condition or by static electricity. Never disconnect the ground wire.
• Wire gauge sizes of electrical wiring, cables, and cord sets must be adequate to han-
dle the maximum electrical current (ampacity) to which they will be subjected.
• Before installing or servicing this (and related) equipment, make sure that all power
voltage supplies are completely turned off at their source. Failure to do so will result
This General warning symbol points out important safety infor-
mation that, if not followed, could endanger personal safety
and/or property of others.
This Explosion warning symbol points out potential explosion
hazard(s).
This Fire warning symbol points out potential fire hazard(s).
This Electrical warning symbol points out potential electrical
shock hazard(s).
ELECTRICAL WARNING

Advertisement

loading
Need help?

Need help?

Do you have a question about the SWIFT-E and is the answer not in the manual?

Questions and answers

This manual is also suitable for:

Swift-e+