Scheppach SC38 Instruction Manual page 25

14. Troubleshooting guide
Fault Possible causes
Motor does not start • No electricity in plug
• Cable defective
• Switch, switch/plug block defective
• Connections to motor or capacitor
• Housing clogged
Engine performance • Soil is too firm
drops • Housing clogged
• Roller badly worn
Imprecise scarifying • roller worn
result • Wrong working depth
Motor is running, roller is • Toothed belt is torn
not rotating
disconnected
www.scheppach.com
Rectification
• Check line and fuse
• Have machine checked by a customer ser-
vice center
• Have machine checked by a customer ser-
vice center
• Have machine checked by a customer ser-
vice center
• If necessary adjust working depth. Clean
housing so that the roller can run freely
• Change working depth
• Clean housing
• Replace roller
• Replace roller
• Correct working depth
• By customer service workshop
GB | 25