HOMCOM 821-032V70 Manual page 13

Trouble shootIng
Fault Reason
The power cord is not
connected properly .
The water tank is not properly in
place.
The machine is
The room temperature is above
not running.
95"F (35"C) or below 41 "F(S"C).
The room temperature is
between 68 ° F (20 ° C) and 95 °
F (35 ° C).
Poor
Air flow is poor.
dehumidification
efficiency
The ambient humidity is too low. A normal phenomenon.
Loud noise when Air intake is blocked.
running
The machine is placed at an angle. Place the appliance on a level surface.
The hose is connected without
Drain hose
removing the grey rubber plug
properly
from the water outlet.
connected, but
The pipe is not properly
water leaks or
connected, or the other end of
drains into the
the pipe is blocked, preventing
tank.
proper water discharge.
The tank is full or not properly installed.
The sensor float in the tank got
Dehumidifier fails
stuck and did not reposition
to operate
properly.
despite being
started.
The dehumidifier is in the
defrosting process.
Not e :
Before starting the appliance, ensure the air outlet is open to prevent overheating.
Avoid stopping the appliance abruptly by unplugging the power cord. If issues
persist, shut down the machine and unplug the power plug.
Solution
Ensure the plug is firmly connected to a
power socket.
Drain the water from the tank, then place
it back into its correct position.
The appliance is not suitable for e x treme
environments, so it will automatically turn
off – this is normal.
The machine will cool automatically, which
is normal.
There should be about 7.9 inches (20cm)
of space around the product.
Remove dirt from the air inlet and outlet
of the product.
Before connecting the water pipe, ensure
to pull out the grey rubber plug from the
water outlet.
After connecting the water pipe, make
sure that both ends are unobstructed. It is
recommended to keep the water pipe in
an inclined state to aid gravity drainage.
Empty the tank and install it properly into
the appliance.
Push the float down to the lowest position
for the correct float position.
The defrosting process may take 15 - 20
minutes.When the defrosting is complete,
the dehumidifier automatically starts to
continue the dehumidification process.
12