Plikc NEVE PRO User And Installation Manual page 9

5+2 Mode
1. Press the PRG button once.
2. Press the up or down buttons until the days "MON-TUE-WED-THU-FRI" start flashing.
3. Press the SET button once, and Phase 1 and the time will start flashing. Use the up or down
buttons to adjust the start time of the phase.
4. Press SET again and use the up or down buttons to set the desired temperature, then press
SET to confirm.
5. At this point, Phase 1 is set, and you will proceed to Phase 2. Repeat the steps described
above to program the following daily phases.
6. Once all daily phases are programmed, the thermostat will return to Phase 1, and the days
"MON-TUE-WED-THU-FRI" will flash.
7. Press the PRG button until the days "SAT-SUN" flash.
8. Repeat the programming procedure from step 3 to step 4.
9. When both groups are set to the desired settings, press HOME to confirm or wait 60 seconds
for the automatic confirmation..
16
Plikc S.r.l. - Via del Lago Terrione, 83 - 00165 Roma - info@plikc.com - www.plikc.com
7 days Mode
1. Press the PRG button once.
2. Press the up or down buttons until the days "MON-TUE-WED-THU-FRI-SAT-SUN" start fla-
shing.
3. Press the SET button once, and Phase 1 and the time will start flashing.
4. Use the up or down buttons to adjust the start time of the phase.
5. Press SET again and use the up or down buttons to set the desired temperature, then press
SET to confirm.
6. At this point, Phase 1 is programmed, and you will proceed to Phase 2. Repeat the steps de-
scribed above in steps 3 and 4 to program the subsequent daily phases.
7. Once all the daily phases are programmed, the thermostat will return to Phase 1, and the days
"MON-TUE-WED-THU-FRI-SAT-SUN" will flash.
8. Press HOME to confirm the settings or wait 60 seconds for automatic confirmation.
Plikc S.r.l. - Via del Lago Terrione, 83 - 00165 Roma - info@plikc.com - www.plikc.com 17