Plikc NEVE PRO User And Installation Manual page 10

24 Hours Mode
1. Press the PRG button once.
1. Press the up or down buttons until the day "MON" (Monday) starts flashing.
2. Press the SET button once, and Phase 1 and the time will start flashing. Use the up or down
buttons to adjust the start time of the phase.
3. Press SET again and use the up or down buttons to set the desired temperature, then press
SET to confirm.
4. At this point, Phase 1 is programmed, and you will proceed to Phase 2. Repeat the steps de-
scribed above in steps 3 and 4 to program the subsequent daily phases.
5. Once all daily phases are programmed, the thermostat will return to Phase 1, and the day
"MON" will flash.
6. Press the up button to move to "TUE" (Tuesday).
7. Repeat the steps from step 3 to step 8 until the day "SUN" (Sunday).
8. When all 7 days are programmed, press HOME to confirm the settings or wait 60 seconds
for automatic confirmation.
18
Plikc S.r.l. - Via del Lago Terrione, 83 - 00165 Roma - info@plikc.com - www.plikc.com
Note: If you do not need all 8 daily phases, you can exclude them as follows: once you have
selected the phase to exclude, press the ON/OFF/Clock button. Instead of the time, the display
will show "- - - -". Press SET to confirm. Repeat the same procedure for all phases you wish to
exclude. Keep in mind that if the excluded phase was in the middle (for example, phase 5), the
subsequent phases will shift backward, so phase 6 will become phase 5.
Note: another way to neutralize the daily phases that are not needed is to set them to a tempe-
rature low enough to prevent any possible activation.
For example, set them to 10°C
Manual Operating Modes
The thermostat has 4 manual operating modes:
• Temporary Manual Mode
• Permanent Manual Mode
• Hourly Manual Mode
• Holiday Mode
Plikc S.r.l. - Via del Lago Terrione, 83 - 00165 Roma - info@plikc.com - www.plikc.com 19