Plikc NEVE PRO User And Installation Manual page 14

CL:
6. Minimum Temperature Limit Set to 5°C: This function allows you to limit the minimum
temperature that the user can set. For example, if the CL (minimum limit) is set to 10°C, the
user will not be able to lower the temperature below this limit.
PrOG
7.
: Chronothermostat/thermostat mode selection: ON (chronothermostat) / OFF (ther-
mostat), see dedicated paragraph;
LOC
8.
: Keypad lock mode selection: PA (keypad partially locked) / FU (keypad fully locked).
See dedicated section 'Keypad lock';
AntI:
9. Antifreeze activation / deactivation: ON: when the chronothermostat is switched off it
goes into 'Anti-Freeze' mode / OFF when the chronothermostat is switched off it does NOT go
into 'Anti-Freeze' mode;
ANtI (5.0°):
10. Set antifreeze temperature: Set antifreeze temperature, minimum 0.5°C,
maximum 15°C.
26
Plikc S.r.l. - Via del Lago Terrione, 83 - 00165 Roma - info@plikc.com - www.plikc.com
rESE:
11. Restore factory settings: Press , the display will show '----', then press the key again.
All icons will appear on the display for a few seconds. Then the main screen will return, indica-
ting that the reset was successful.
Plikc S.r.l. - Via del Lago Terrione, 83 - 00165 Roma - info@plikc.com - www.plikc.com 27