Plikc NEVE PRO User And Installation Manual page 6

Setting the Day of the Week and Time
The first thing to do after powering on the device is to set the day and time:
Press and hold the SET button for 5 seconds, and the day of the week will start flashing.
• Select the correct day of the week, from Monday to Sunday, using the up and down buttons.
• Press SET once, and the hour will start flashing. Use the up and down buttons to adjust the
hour from 0 to 23.
• Press SET again, and the minutes will start flashing. Use the up and down buttons to adjust
the minutes from 0 to 59.
• Press SET to confirm the changes and return to the main screen.
10
Plikc S.r.l. - Via del Lago Terrione, 83 - 00165 Roma - info@plikc.com - www.plikc.com
Thermostat or Programmable Thermostat?
The NEVE PRO comes from the factory set to "PrOG ON", which means it is in programmable ther-
mostat mode and ready to be programmed.
If you want to use the device as a simple thermostat (without programming):
Press and hold the SET button for 5 seconds until the display shows HEAT (heating) or COOL (co-
oling). This will enter the settings menu.
• Press the up or down buttons to scroll through the settings menu until you reach "PrOG ON".
• Use the up and down buttons to set it to "PrOG OFF".
• Press SET to confirm the changes and return to the main screen.
Setting PrOG OFF (Thermostat Mode)
Setting PrOG OFF (thermostat mode) allows you to open and close the contact, or turn the system
on and off, simply by adjusting the temperature using the up and down arrows.
In heating mode (HEAT), when the set temperature is higher than the detected temperature, the
flame symbol will appear on the display, and the heating system will turn on.
In cooling mode (COOL), when the set temperature is lower than the detected temperature, the fan
symbol will appear on the display, and the cooling system will turn on.
Plikc S.r.l. - Via del Lago Terrione, 83 - 00165 Roma - info@plikc.com - www.plikc.com 11