Summary of Contents for Estes LIBERTY BELL 7 MERCURY REDSTONE
Page 2
ASSEMBLE TOWER AND CAPSULE Let dry. CAUTION: For safe handling of plastic glue, see manufacturer’s warnings and follow instructions for use. Repeat for other R. Let dry. Let dry. Let dry. Let dry. Let dry. Let dry.
Page 3
Test fit O and P. Scrape sides flat. Let dry. Glue inside seam. Let dry. Let dry. TUBE MARKING Remove guide. Use a door frame to extend all lines. CLEAR TAPE DOOR FRAME CLEAR TAPE NOTE: Cut from page 4. ASSEMBLE ENGINE MOUNT STICK 2 1/4”...
Page 4
TUBE MARKING GUIDE & SHOCK CORD MOUNT NOTE: Make a copy if you want to keep instructions. ASSEMBLE FINS Bevel edge. 1/4” (6 mm) LBS/KG BEFORE AFTER Let dry. 1 mm 1/4” (6 mm) TOP VIEW AFTER BEFORE 1/64” (1 mm) Let dry.
Page 5
INSTALL ENGINE MOUNT Let dry. STICK ATTACH FINS Let dry. Repeat for remaining fins. END VIEW ASSEMBLE AND INSTALL LAUNCH LUGS Let dry. Round edges 1/2” 1/2” (13 mm) (13 mm) BEFORE AFTER NOTE: Use launch rod to check alignment.
Page 6
ASSEMBLE DETAIL PARTS Shape I. Bend Y slightly. BEFORE AFTER AFTER BEFORE Let dry, repeat for remaining I and Y. Check alignment. Let dry. ENDS EVEN EVEN PREPARE RECOVERY SYSTEM DOUBLE KNOT...
Page 7
Insert nose cone NOTE: 10-12 SQUARES into body tube. Recovery wadding and ESTES ® parachute must slide easily into RECOVERY WADDING body tube. If too tight, redo. ROCKET FINISHING NOTE: Please refer to packaging for suggested paint scheme and/or decal placement.
Need help?
Do you have a question about the LIBERTY BELL 7 MERCURY REDSTONE and is the answer not in the manual?
Questions and answers