Estes CLUSTER BOMB BLU-97B EST 2055 Instructions Manual

www.estesrockets.com www.estesrockets.com
Estes® Industries Estes® Industries
1295 H Street 1295 H Street
Penrose, CO 81240 Penrose, CO 81240
PRINTED IN CHINA PRINTED IN CHINA
ASSEMBLY TIP ASSEMBLY TIP
Read all instructions before Read all instructions before
beginning work on your model. beginning work on your model.
Make sure you have all parts Make sure you have all parts
and supplies. and supplies.
PARTS PARTS Locate the parts shown below and lay them out on the table. DO Locate the parts shown below and lay them out on the table. DO
NOT USE THE DRAWINGS TO ASSEMBLE YOUR ROCKET. NOT USE THE DRAWINGS TO ASSEMBLE YOUR ROCKET.
HELPFUL HINT: HELPFUL HINT:
IF NOSE CONE/COUPLER FIT IS. . . IF NOSE CONE/COUPLER FIT IS. . .
TOO TOO
TOO TOO
TIGHT TIGHT
LOOSE LOOSE
ADD ADD
MASKING TAPE. MASKING TAPE. SAND FOR FIT. SAND FOR FIT.
Mylar Retainer Mylar Retainer
Ring (1) Ring (1)
(30168) (30168)
Shock Cord Shock Cord
Clay Weights (2) Clay Weights (2)
1/4" x 18" (1) 1/4" x 18" (1)
(38380) (38380)
Orange Streamers (4) Orange Streamers (4)
(60034) (60034)
SUPPLIES SUPPLIES
In addition to the parts included in the kit you will also need: In addition to the parts included in the kit you will also need:
SCISSORS SCISSORS PENCIL PENCIL RULER RULER
Launch Lugs (2) Launch Lugs (2)
(38175) (38175)
Green Engine Green Engine
Block (1) (30162-2) Block (1) (30162-2)
Engine Hook (1) Engine Hook (1)
(85705) (85705)
Decal Sheet (1) (60563) Decal Sheet (1) (60563)
MASKING MASKING
FINE SAND FINE SAND
TAPE TAPE
PAPER PAPER
(#400-600 GRIT) (#400-600 GRIT)
EST 2055/1246 EST 2055/1246
TEST FIT ALL PARTS TOGETHER TEST FIT ALL PARTS TOGETHER
BEFORE APPLYING ANY GLUE! BEFORE APPLYING ANY GLUE!
If any parts don't fit properly, sand as If any parts don't fit properly, sand as
required for precision assembly. required for precision assembly.
Body Tube BT-70 (1) (30413) Body Tube BT-70 (1) (30413)
Engine Mount Tube (1) Engine Mount Tube (1)
BT-20 (30329) BT-20 (30329)
Yellow Spacer Tool (1) Yellow Spacer Tool (1)
(35003) (35003)
(35021) (35021)
Cluster Bombs (4) Cluster Bombs (4)
(72662) (72662)
Die-Cut Balsa Die-Cut Balsa
Fins (2) (32217) Fins (2) (32217)
CARPENTER'S CARPENTER'S PLASTIC PLASTIC
MODELING MODELING
GLUE GLUE CEMENT CEMENT
FLYING MODEL ROCKET FLYING MODEL ROCKET
KIT INSTRUCTIONS KIT INSTRUCTIONS
Keep for Future Reference Keep for Future Reference
Plastic Nose Cone Plastic Nose Cone
Half A (1) Half A (1)
(60558) (60558)
Plastic Tail Cone Plastic Tail Cone
Half A (1) Half A (1)
(60560) (60560)
Centering Ring Centering Ring
Card (1) (60562) Card (1) (60562)
Assembled 12" (30 cm) Assembled 12" (30 cm)
Parachute (1) (35801) Parachute (1) (35801)
PAINT PEN PAINT PEN
SPRAY SPRAY
(SILVER) (SILVER)
KNIFE KNIFE PRIMER PRIMER
(WHITE) (WHITE)
SHOCK CORD SHOCK CORD
MOUNT MOUNT
3 3
SECTION SECTION
2 2
SECTION SECTION
1 1
SECTION SECTION
Plastic Nose Cone Plastic Nose Cone
Half B (1) Half B (1)
(60559) (60559)
Plastic Tail Cone Plastic Tail Cone
Half B (1) Half B (1)
(60561) (60561)
Enduring Freedom Enduring Freedom
Sticker (1) (60586) Sticker (1) (60586)
SPRAY PAINT: SPRAY PAINT: SPRAY DULL SPRAY DULL
(OLIVE DRAB, (OLIVE DRAB, COAT COAT
LIGHT GRAY) LIGHT GRAY) (OPTIONAL) (OPTIONAL)