Dell PowerEdge E05S Owner's Manual page 109

5 Lift the expansion-card latch and remove the filler bracket. See
Figure 3-16.
NOTE:
system board, go to step 7.
6 Holding the card by its edges, position the card so that the card-edge
connector aligns with the expansion-card connector.
7 Insert the card-edge connector firmly into the expansion-card connector
until the card is fully seated.
8 Replace the expansion-card latch. See Figure 3-16.
Figure 3-16. Installing and Removing an Expansion Card
3
1 expansion-card latch
3 expansion-card connector
To install an expansion card in the expansion-card connector on the
2 expansion card
Installing System Components
1
2
109