JVC BD-X200U - Dvd Authoring Recorder Instructions Manual page 67

Editing Via the REMOTE CONTROL (DV SLAVE) Screen
A keyboard and mouse can be used as an alternative to the DVD recorder's buttons when using the REMOTE CONTROL (DV
SLAVE) screen.
Front panel : Select using the cursor buttons (t, 8, 7, and 6), and confirm the selection using the SET button.
: Select using the arrow keys (†, ©, √, and ∞), and confirm the selection using the Enter key.
Keyboard
Mouse : Left click the required button.
* Setting of the In Point, Out Point, and chapter points can only be carried out by keyboard input.
In Point (start point for editing):
Set the time code (hours : minutes : seconds : frames) at
which recording is to be started.
Chapter list:
This displays the time
codes of chapter
marks. These time
codes are displayed as
relative values with
respect to the In Point.
The In Point's time
code is registered as
the first chapter point.
A total of 98 chapters
can be setup.
C H A P T E R
CREATION from the
RECORDER [2/2]
MENU screen must
be set to MANUAL
for this to be possible.
CHAPTER:
The right-hand field indicates
the current setting for
CHAPTER CREATION from
the RECORDER MENU (2/2)
screen.
When set to MANUAL,
chapter marks can be
registered in this screen's
chapter list.
When set to AUTO, the
DVD recorder's chapter
auto-create function will set
chapters. In such a case, it
will not be possible to
register chapters using this
screen's chapter list.
Chapter marks
inserted at GOP intervals
(i.e., 15 frames). It will not
be possible to inser t
chapter marks that are
closer together than this
interval.
REMOTE CONTROL SCREEN ( DV SLAVE )
IN POINT
EXIT
: : :
h m s f
1 00:00:00:00
4
00:25:00:00
7
00:40:00:00
CHAPTER
ADJ
BITRATE
TC CANCEL
ADJUST:
This button can be
pressed to determine
the remaining disc time
based on the editing
time and also to set a
suitable bit rate. This
setting is then displayed
in the BIT RATE field.
are
OUT POINT (end point for editing):
Set the time code (hours: minutes: seconds: frames) of
the position to stop recording.
00:00:00:00
OUT POINT
: : : :
h m s f h m
2 00:15:00:00 3 00:20:00:00
5 6
00:30:00:00 00:35:00:00
8 9
00:45:00:00 00:50:00:00
:
TC INPUT
MANUAL
8.0 Mbps DISC REMAIN
EDL LOAD FINALIZE
TC CANCEL : This button is used to remove setting values
EDL LOAD : This button is used to load the most-recent
TC INPUT:
This field is used to input
time codes for the In
00:10:00:00
Point, Out Point, and
chapter marks from the
: :
s f
keyboard.
DISC REMAIN:
: :
This field shows an
estimate of the remaining
000 min
space for recording on the
disc.
FINALIZE:
This button is used to
finalize the disc.
for the In Point, Out Point, and chapter marks.
edit list. It can be used whenever CREATION
CHAPTER has been set to MANUAL.
65