Page 13
Instruction Manual Ver 1.00 TP-940 Merak Pro.
Page 14
For safety, read the following instruction manual before use. Please keep it safe for future reference. Finally, if you find anything that you do not understand in the description or any problems with the product, please stop use immediately and contact the retailer or Snow Peak Customer Service.
WARNING Misuse could result in serious injury or death. ●Before using the product, check each part for abnormalities. If there are abnormalities, take the product to the dealer or Snow Peak Customer Service for inspection or repair. ●Always pay close attention to weather conditions. If bad weather (such as heavy rain, snowfall, strong winds, thunder, etc.) is expected, promptly cancel camping and evacuate to a safe location.
Page 16
Shelter setup procedure * To help ensure safety, this procedure should always be carried out by two or more people. Please practice setting up and disassembling the tent repeatedly according to the following explanation in order to prepare to use it for camping. Make sure that you have all the accessories you need in advance.
Page 17
Insert the ring pin with the gray peg-down loop at the hem of the main body (triangular window) into the tip of the A pole. Attach it to the tip of the A pole and pull the adjuster belt to apply tension. Perform the same procedure on the other side. A pole Ring pin Peg-down loop...
Page 18
Insert the ring pin with the black peg-down loop into the end of the C pole ①. Do the same for the C pole on the other side. Do not attach the other C pole before inserting the C pole and ring pin. CAUTION Otherwise, a large load may be applied to the ridge pole, which may damage the product.
Page 19
Secure the intersection of the C pole ① and C pole ② using the Velcro attached to the main body. When doing so, pass the Velcro through them so that the two poles are bundled together. (2 locations) Next, raise the ventilation bar and secure it using the Velcro. (2 locations) * Pole intersection C pole ②...
Page 20
If you intend to use it as the SET-940 (Merak Pro. Stove Plus), please follow the setup procedures in the SET-940 Instruction Manual from this point onward. Attach the rope with a rope tensioner and insert the pegs as shown in the figure below. (2 m / 6.6’ x 12, 3.5 m / 11.5’ x 4) * Since this shelter is large, we recommend that you use forgeable pegs that are 30 cm / 11.8”...
Page 21
As shown in the figure below, cover the ceiling of the Merak Pro. main body with the shield roof, and wrap the Velcro for the C pole ② on the opposite side around the C pole ②. Wrap the Velcro for the ridge pole around the ridge pole to secure it. Next, hang the center ring on the tip of the ridge pole and pull the adjuster belt tight.
Page 22
What to do in case of strong winds This product is equipped with accessories that provide stability against strong winds from the front. Set up the included belts with rings and the four 5 m /16.4’ ropes with a rope tensioner as shown in the figure below. WARNING This is just an assisting measure.
Page 23
●When using the product again after not using it for a long period of time, inspect the product and its included items. If you have any questions, please contact Snow Peak Customer Service. ●A polyester fabric blend is used for this product. Considering the material characteristics, we adopted processing and color patterns that will result in less color migration.
Snow Peak Customer Service. If there are apparent defects in the product's manufacturing, the defective product will be repaired or exchanged free of charge. In other cases, Snow Peak will repair the product for an appropriate fee. The decision to repair or replace the product will be at our discretion.
Need help?
Do you have a question about the Merak Pro TP-940 and is the answer not in the manual?
Questions and answers