Chain Dialing; Voice Message Notification - Uniden D1660 User Manual

Handset to Handset Intercom
♦ Whenever the phone is in standby, you can make an intercom call
between handsets without using the phone line.
♦ You can make an intercom call from any handset, but only two handsets
can be in an intercom call at any time.
♦ If an outside call comes in during an intercom page, the phone cancels
the page so you can answer the incoming call.
♦ If an outside call comes in during an intercom call, press
hang up the intercom call and answer the outside call.
To...
make an intercom
page
cancel a page
answer a page
end an intercom call

Chain Dialing

If you often have to enter a series of digits or a code number during a
call, you can save that code number to a phonebook entry and use the
phonebook to send the code number.
1. Enter the code number (up to 20 digits) into the phonebook just like
a regular phonebook entry. Be sure to enter the code number into the
phonebook exactly as you would enter it during a call.
2. When you hear the prompt that tells you to enter the number, open the
phonebook and find the entry that contains your code number.
3. Press
MEnu/sElEcT
the phonebook.

Voice Message Notification

♦ If you subscribe to a voice mail service, your phone can notify you when
you have a new message. This feature supports Frequency-Shift Keying
(FSK) notification. Contact your voice mail provider for information.
♦ When you have new messages, the display shows a message icon. After
you listen to your messages, the message icon turns off. If it doesn't, you
can reset it: With the phone in standby, open the menu and select
Setup; select VMWI
12
Press...
inTErcoM/clEar.
with, or All to page all handsets at the same time.
End .
inTErcoM/clEar
End . Both handsets return to standby.
to send the code. If you change your mind, just close
Reset, then select
Select the handset you want to talk
or Talk/Flash .
Yes.
to
Talk/Flash
Global